3d printed autosyphon for aquaponics

An attempt at creating an autosyphon for aquaponics that works with a wider range of input/ output flows than bell syphons (for small systems)

It also it is close to 100% 3d printed , as you only need a bit of fishing line, so cheap and reproducible :)

Bad news is: my aquaponics is too small to tweak and test it reliably (balance between counterweight \

Since published on 01 01 2016 - 17:14:51 This video has been viewed 458 times, in the audience there are 4 likes, and The number that hates this Video is: 0. This video is favorited by 0 people and has been commented on as many times as 0 times, Videos that have this 3 Minute(s) 26 Second(s) Length, entered in CategoryScience & Technology

Video yang berjudul 3d printed autosyphon for aquaponics dipublikasikan oleh Channel Mark Moissette dengan Channel ID UCT8zQep4liUC4HjyO916lCQ pada 01 01 2016 - 17:14:51

p> Videos Related Videos 3d printed autosyphon for aquaponics

• aquaponics
  
  
  
  
• Aquaponics Greenhouse Structure Update
  
  Update on Aquaponics Greenhouse structure using FreeCAD
  The build is planned for August as one of our workshops ...
  
  
• Aquaponics : Testing My Cheap Home Made Bell Siphon
  
  I made this bell siphon with unused coke bottle.
  
  
• How To Set Up Aquaponics System Indoors and Outdoors - Aquaponics Basics Video compilations
  
  Discover How To Set Up Aquaponics System Both Indoors and Outdoors
  Barrel, Intermediate Bulk Container, Biofilter making for fish, mosquito prevention, ...